Fill Dirt in Hartford, SD

Fill-dirt is usually cheaper than decorative gravel in Hartford because it is less processed and often sourced locally. Prices vary by supplier and moisture content, but fill-dirt is commonly used for raising grade or backfill where appearance is not important. Check our site or get a quote to see current local pricing and remember our 3-ton minimum order.

A typical tri-axle dump truck delivers about 10 to 14 cubic yards of loose fill-dirt (actual tons vary with moisture and soil type). Delivered truck costs in West South Dakota depend on quantity and distance, so expect different quotes; use Hello Gravel's calculator or request a quote for an accurate delivered price and scheduling (standard delivery is 2+ business days).

The amount depends on depth: 2 inches ≈ 6.2 cubic yards, 3 inches ≈ 9.3 cubic yards, 6 inches ≈ 18.5 cubic yards, and 12 inches ≈ 37.0 cubic yards. These are loose volumes; compaction can reduce final volume, so order a little extra or contact Hello Gravel for a tailored calculation for Hartford soil conditions. Remember our minimum order is 3 tons, so small jobs may still hit that threshold.

'Poor man's concrete' generally refers to a low-cost base made from compacted fill or gravel sometimes mixed with a bit of cement or fines to harden the surface. Fill-dirt can be part of that base, but in Hartford's freeze-thaw climate it won't perform like real concrete, so it's not a substitute for structural slabs or load-bearing surfaces. For driveways, patios, or foundations, ask a contractor or our team about proper base materials and compaction requirements.

No, 2 inches of fill-dirt is not sufficient for a driveway or structural base. Driveway bases typically require 4 to 8 inches of well-graded, compactable material (gravel or crushed stone) and proper compaction—fill-dirt alone may be too soft, retain water, and be prone to frost heave in South Dakota. If you want the finished grade raised slightly, a thin layer of fill-dirt can be used under a proper aggregate base; request tailgate spreading if needed and note this is at the driver's discretion.

For a typical single-car 20 ft long by 10 ft wide driveway (200 sq ft), you'll need about 2.5 cubic yards for a 4-inch layer or about 5.0 cubic yards for an 8-inch layer. Delivered costs vary by local supplier and amount; use Hello Gravel's online calculator or get a quote for Hartford to see delivered price, and remember small jobs may hit our 3-ton minimum order.

Coverage depends on depth and soil density, but 10 tons of fill-dirt is roughly about 6 to 8 cubic yards in typical local soils. That would cover approximately 900 to 1,300 square feet at a 2-inch depth, or about 150 to 200 square feet at a 6-inch depth; for an exact figure, use our material calculator or request a site-specific estimate from Hello Gravel.