Fill Dirt in Pickerington, OH

Fill dirt is generally cheaper per ton than gravel because it is a lower-spec material without stone or decorative value. However you should compare by the amount and purpose: gravel may require less volume to reach the same grade and provides drainage, so overall project cost can vary. For most backyard leveling and basic fill in Pickerington, fill dirt is the more economical choice.

Delivered fill dirt prices in Pickerington typically fall in a range rather than a single number. Expect roughly $12–$35 per ton delivered depending on the supplier, haul distance, and the amount ordered, with better per-ton pricing on larger loads. Exact pricing is available at checkout after you enter your zip code and desired quantity.

One ton of fill dirt in the Pickerington area commonly costs about $12–$35 delivered, depending on local pit rates and trucking. Small orders and short-notice deliveries tend to be toward the higher end of that range. Hello Gravel’s minimum order is 3 tons, which often lowers the per-ton rate.

Fill dirt is soil used to raise grade and fill voids; it is made mostly of mineral soil with little to no stones and little organic matter. Gravel is composed of crushed rock or rounded stones and is used for drainage, driveways, and decorative surfaces. For structural base or drainage in Pickerington yards, contractors usually place compacted fill dirt first and then a gravel base if needed.

A 10-yard load of fill dirt is roughly 12–14 tons depending on moisture and compaction. In Pickerington you can expect delivered prices roughly in the $150–$500 range for a 10-yard load, with the final cost depending on supplier, delivery distance, and site access. Request a quote through Hello Gravel to see a local, exact price.

You can put gravel over fill dirt, but preparation matters: the fill dirt should be placed in lifts and compacted to avoid future settlement. If the fill is loose or contains organic material, put a compacted crushed stone base or geotextile fabric between the fill and top gravel to improve stability and drainage. In Pickerington’s clay-prone areas, proper compaction and a stone base reduce future rutting and pooling.

A typical tri-axle truck delivers about 10–14 cubic yards (about 12–18 tons) of loose fill dirt. Delivered cost for a single truckload in Pickerington commonly ranges from about $200 to $700 depending on load size, exact tonnage, and travel distance. For the most accurate price, use Hello Gravel’s online quote for your exact address and material needs.

Coverage depends on depth. One ton of fill dirt is about 0.75–0.85 cubic yards, so at 2 inches depth it covers roughly 120–130 square feet, at 4 inches it covers about 60–65 square feet, and at 6 inches about 40–45 square feet. Always add 5–10% extra for compaction and settling when ordering for Pickerington projects.

Spring and fall are usually the best times to place fill dirt in Pickerington because soils are workable and the weather is mild. Avoid working on saturated ground after heavy rains and be cautious with frozen ground in winter because compaction and grading are harder. Summer is fine for deliveries, but very dry conditions can make compaction easier or harder depending on soil moisture, so coordinate with your contractor.

Ordering larger quantities from a local supplier or arranging delivery with a nearby construction site that has surplus material can lower per-ton costs. Using Hello Gravel to compare local suppliers and schedule deliveries usually finds competitive pricing and can eliminate extra broker fees. Avoid unpaid or unknown-source fill—verify material and permits if you’re filling drainage areas or regulated spaces in Pickerington.

Whether one ton will fit depends on your truck’s payload capacity and the truck bed volume. One ton of fill dirt is roughly 0.75–0.85 cubic yards, which may fit volume-wise but could exceed a small pickup’s safe payload if the truck has low capacity. Check your vehicle’s GVWR and payload rating before hauling; when in doubt, use a professional delivery through Hello Gravel to avoid damage or safety hazards.

Yes, fill dirt is commonly used to raise low spots and level yards, especially when you need structural, non-organic material below topsoil. For a lasting result in Pickerington, place fill dirt in thin lifts and compact each layer, then finish with topsoil if you plan to seed or sod. If drainage is a concern, consult a local contractor to ensure grading directs water away from foundations.

If you’re placing gravel over fill dirt, first compact the fill in layers and then add a compacted base of crushed stone (such as 3/4-inch crushed stone) before the finish gravel. Installing a geotextile fabric between the fill and stone helps prevent mixing and improves stability, especially in Pickerington’s clay soils. This approach improves drainage and prevents the gravel surface from sinking into the fill over time.