Fill Dirt in Huber Heights, OH

Delivered fill dirt prices in Huber Heights vary by supplier, delivery distance, and moisture content, but a ballpark range is about $12 to $30 per cubic yard delivered. A typical tri-axle dump truck carries roughly 10 to 12 cubic yards, so expect a 10-yard load to run roughly $120 to $300 before any extra fees. Exact pricing is available by entering your zip code on our site or calling our team for local quotes.

Yes—fill dirt is usually cheaper than crushed gravel or crushed stone because it is lower-value material and often locally available. Gravel has processing and screening costs and is priced for use as a wearing surface, so if you only need to raise grade or fill holes, fill dirt will typically save you money. If you need a stable driveway or drainage layer, factor in the cost of gravel on top of fill dirt.

As a rough estimate for Huber Heights, fill dirt often costs about $12 to $30 per cubic yard delivered and roughly $9 to $22 per ton, depending on source and moisture. Fill dirt density varies with moisture and compaction; a common conversion used locally is about 1.2 to 1.4 tons per cubic yard, so your per-ton price will depend on which unit the supplier uses. For firm pricing, check availability for your zip code on Hello Gravel or request a quote.

Using the per-cubic-yard range above, a 10-yard load of fill dirt in Huber Heights typically costs about $120 to $300 delivered, while a 20-yard load is roughly $240 to $600. Prices change based on exact pickup location, the truck size, and whether the material is clean fill or contains clay/organics. Hello Gravel shows local supplier quotes during checkout so you can compare exact costs for those load sizes.

To estimate, we need width and desired depth. For a common 20-ft long by 10-ft wide driveway at 4 inches of fill, you need about 2.5 cubic yards (roughly 3.2 to 3.5 tons). At typical Huber Heights prices, that 2.5 yd3 of fill dirt would run roughly $30 to $75 plus delivery; however, driveways usually require a crushed-stone base and wearing surface, so plan for additional stone costs and larger volumes if you are raising or stabilizing the whole driveway.

Fill dirt is fine for raising grade or filling low spots and compacts reasonably well, but it is not a durable wearing surface for driveways. For a driveway, use fill dirt to build up grade only if needed, then install a compacted crushed-stone base and a gravel or crushed-stone surface on top for long-term stability and drainage. If you only plan a simple passable surface, order both materials: fill dirt for subgrade adjustments and crushed stone for the driving surface.

Pickup truck capacity varies by model and payload rating, but 1 ton of fill dirt is roughly 0.7 to 0.9 cubic yards depending on moisture, and many full-size pickups can carry close to that weight if the payload rating allows. Keep in mind Hello Gravel's minimum order is 3 tons, and we deliver by dump truck fleets; for most online orders you'll receive a truck delivery rather than individual pickup loads. If you prefer to pick up small amounts, contact local suppliers directly and confirm your truck's payload before loading.

One cubic yard equals 27 cubic feet and will cover about 162 sq ft at 2 inches depth, 81 sq ft at 4 inches, and 54 sq ft at 6 inches. Using a typical conversion of about 1.2 to 1.4 tons per cubic yard, one ton of fill dirt will cover roughly the same areas scaled by that conversion (for example, one ton is roughly 0.8 to 0.9 yd3). Always calculate using cubic yards for area/depth work and add 10-20% for settling and compaction.

Two inches of gravel over fill dirt is not enough for a long-lasting driveway; it will rut and wash out under vehicle traffic. A common recommendation is 4 to 6 inches of compacted crushed stone for the base, plus 2 to 3 inches of smaller stone or crusher-run as a surface, with thicker sections for heavier vehicles. Use fill dirt only to adjust grade below the compacted stone layers; your Hello Gravel order can include both fill dirt and the appropriate crushed stone when needed.

To lower delivered cost in Huber Heights, order larger volumes (cost per yard usually drops with bigger loads), be flexible on delivery date so drivers can combine loads, and compare multiple local supplier quotes through Hello Gravel. Avoid materials labeled as 'topsoil' or 'clean fill' without checking content, since extra hauling fees can apply for contaminated or high-moisture loads. Always confirm minimums, delivery fees, and whether the truck can access your drop location before ordering.

Drivers may be able to perform tailgate spreading at their discretion, but spreading fill dirt can be heavy and may require additional equipment or labor, so it is not guaranteed. Request spreading in the Order Notes at checkout and the driver will assess safety and feasibility on arrival. If you need precise leveling and compaction, plan on hiring local labor or renting a plate compactor or skid-steer after delivery.