Stone in Columbus, OH

Delivered stone in Columbus commonly ranges from about $30 to $60 per ton depending on the type (washed stone, crushed, or decorative), distance from the quarry, and seasonal demand. Heavier or specialty stone and short-notice deliveries can push the price higher, and Hello Gravel can provide an exact local quote for your zip code.

For driveways, a 3/4u0022 crushed stone or #57 is commonly used as a base and crusher-run or 1/4u0022 fines make a stable surface. Pathways often use pea gravel (3/8u0022) or 3/8u0022 crushed stone for walking surfaces. Regional sourcing means exact names and mixes vary around Columbus, so check photos or samples when ordering.

Spring through early fall is the best time to buy and install stone in central Ohio because ground conditions are easier and suppliers are fully operational. Winter deliveries can be limited by frozen ground, snow, and municipal hauling restrictions, so plan ahead for late fall or schedule spring delivery to avoid weather delays.

Yes. Hello Gravel connects you with prequalified local suppliers and hauling fleets in Columbus that offer delivery, and many offer tailgate spreading at the driver's discretion for an extra fee. Request spreading in your order notes and contact our team if you need help confirming spreading or other on-site services.

Freeze-thaw cycles in Columbus can cause settling, rutting, and potholes, especially where subgrade is clay or drainage is poor. Proper drainage, a well-compacted subbase, and periodic top-up of surface stone reduce freeze-thaw damage and keep the driveway stable year to year.

Use this formula: tons = area (sq ft) * depth (in inches) / 324 (approximate). For example, a common 2-car driveway of 24' x 40' = 960 sq ft; at a 4u0022 compacted depth you would need about 12 tons (960 * 4 / 324 = 11.85). Always order 5-10% extra to allow for compaction, grading, and waste, and remember our minimum order is 3 tons.

City rules and HOA covenants vary, so check Columbus building/zoning and your neighborhood covenants before starting work. Permits may be required for curb cuts, changes to drainage, or alterations to impervious surface regulations, and HOA rules often control surface material and appearance.

Installed gravel/stone driveways typically cost about $1 to $3 per sq ft up front, crushed limestone is similar depending on mix, and asphalt usually runs $3 to $7 per sq ft installed. Gravel has lower initial cost but higher routine maintenance, while asphalt has higher upfront cost and lower frequent maintenance needs; local labor and base prep needs in Columbus will affect final prices.

On clay soils, remove topsoil, install geotextile fabric, and build a robust, well-draining subbase of 6u0022 to 8u0022 of compacted 3/4u0022 crushed stone before adding a 2u0022 to 3u0022 surface layer. Create a crowned profile for runoff and, if needed, add French drains or edge drains to keep water away from the subgrade to prevent heaving and ruts.

Expect light maintenance yearly—raking, filling low spots, and addressing weeds—and heavier upkeep every 1 to 3 years such as regrading and adding 1 to 3 tons of stone depending on driveway size and traffic. Typical small driveway upkeep can run from about $100 to several hundred dollars per event; more extensive refreshes after severe freeze-thaw seasons may cost more.