Fill Dirt in Wingate, NC

Delivered fill dirt prices in Wingate commonly range by supplier and haul distance; expect roughly $10 to $30 per cubic yard (about $8 to $25 per ton) in many cases. Final cost depends on moisture content, screening, delivery distance from local quarries or pits, and whether spreading is requested—check your zip code on Hello Gravel for precise quotes.

To raise 1,000 sq ft by 6 inches you need about 18.5 cubic yards of material (1000 ft2 x 0.5 ft = 500 ft3 ÷ 27 = 18.5 yd3). Using a typical conversion of about 1.2 tons per cubic yard, that equals roughly 22 to 23 tons; add 10-20% extra for settlement and compaction, so order about 25 to 28 tons.

Permit requirements vary by project size and whether the fill changes drainage or disturbs more than a small area. For large fills, fills that alter stormwater flow, or work near streams you should check with Union County and the Town of Wingate planning or stormwater departments—they may require grading permits, erosion control plans, or sedimentation permits.

Wingate sits in a humid, clay-prone part of North Carolina; clay holds water and can make compaction harder when wet and drainage slower. For reliable results, install fill in thin lifts with proper compaction, add drainage layers or gravel where needed, and avoid placing or compacting fill during prolonged wet weather.

Hello Gravel’s minimum order is 3 tons, but typical local dump trucks are tri-axles or end dumps that carry about 10 to 20 tons (roughly 8 to 15 cubic yards). Suppliers also use smaller trucks for tight-access sites; Hello Gravel coordinates the right truck based on your driveway access and amount ordered.

Fill dirt is fine for raising grade or filling low spots but it is not a durable wearing surface for driveways. In Wingate’s clay soils, a well-draining crushed stone base with geotextile fabric is the better choice for driveways because it provides load-bearing strength and proper drainage.

Labor and equipment rates vary, but expect contractors to charge roughly $60 to $120 per hour for small equipment and operator rates in the Wingate area, or about $5 to $15 per cubic yard as a general guideline when included in a larger grading job. Final costs depend on site access, slope, required compaction standards, and whether hauling or additional materials are included.

Yes—on slopes or where clay subsoils are present, a layer of geotextile fabric and a drainage layer (gravel or drainage stone) help prevent mixing, reduce slippage, and improve runoff control. For steeper slopes or areas with concentrated flow, consult a contractor or engineer to specify fabric type and drainage details for local conditions.

A well-compacted, well-drained fill area can remain stable for many years, but expect some settlement during the first 6 to 12 months and plan to top up low spots. Maintenance includes regrading after settling, fixing erosion issues, keeping vegetation or mulch to prevent erosion, and maintaining drainage paths, especially after heavy rains.

Yes—many local suppliers offer screened fill (fewer rocks and debris) or engineered fill with specified gradation and compaction characteristics. For building pads, near foundations, or critical grade work in Wingate’s clay soils, the extra cost is often worth it; for simple berms or non-structural landscaping fills, standard fill dirt is usually sufficient.