Fill Dirt in Columbus, GA

Prices for fill dirt near Columbus typically range based on local supply, quality, and delivery, but expect roughly $10 to $30 per ton as a general guide. Regional factors like clay content and distance from supply can change cost, and Hello Gravel will show exact pricing for your zip code at checkout.

Across Georgia the per-ton price for basic fill dirt commonly falls between $10 and $30 per ton depending on the supplier and region. For an accurate quote in Columbus, enter your zip code on our site or contact our team for local rates and delivery fees.

Yes, basic fill dirt is usually cheaper than gravel and many sands because it is lower-spec material used for filling and grading rather than surfacing. Keep in mind that if you need compaction, engineered fill, or clean fill dirt with low organic content, the price can be closer to sand or gravel costs.

Cost for a single dump truck load depends on the truck size, material price, and delivery distance; a tri-axle load (common for deliveries) can carry roughly 12 to 18 tons of fill dirt. Multiply the per-ton price by expected tons and add any delivery fee or access charge; Hello Gravel will calculate exact delivery pricing during checkout.

A typical tri-axle dump truck used in our network usually carries about 12 to 18 tons of fill dirt, depending on moisture and local weight limits. Smaller trucks carry less, so confirm truck size when you request a delivery date.

One ton of fill dirt covers roughly 0.8 to 1.0 cubic yards, which will spread about 40 to 50 square feet at 1 inch depth. Coverage varies with moisture and compaction, so measure the volume you need (cubic yards) for the most accurate estimate.

Two inches of fill dirt is generally too thin for most grading or building-base needs and will compress significantly after compaction and settling. Use at least 4 to 6 inches for simple yard leveling and follow local code or an engineer recommendation for structural or drainage work.

Fill dirt alone is not recommended as a finished driveway surface because it compacts and erodes; it can be used as subgrade to raise or level before installing gravel or paving. For a 20 ft long driveway, calculate the cubic yards needed for your desired thickness, convert to tons (about 1.2 tons per cubic yard), and then get a Hello Gravel quote — costs vary by material quality and delivery, and you'll likely need additional gravel or base material on top.

Basic fill dirt is usually cheaper than construction sand because sand often has processing and screening costs and specific gradation requirements. However, the best choice depends on your project: sand is better for drainage and bedding, while fill dirt is used for bulk earth-moving and grade changes.

To keep costs down, order in larger volumes to lower the per-ton delivery cost, choose standard delivery windows (2+ business days), and check for nearby suppliers on Hello Gravel to reduce haul distance. Avoid last-minute or next-day delivery when possible and request a quote so you can compare unit prices including delivery.

Avoid putting fill dirt in floodplains or wetlands without permits, over buried utilities, or directly against building foundations without proper compaction and drainage planning. Also avoid using fill dirt with high organic matter for structural fills; ask for screened or clean fill if you need reliable compaction.

Measure the area and desired depth in feet, multiply length × width × depth to get cubic feet, then divide by 27 to convert to cubic yards and multiply by about 1.2 to estimate tons. If you prefer, use Hello Gravel’s material calculator or request help from our sales team with your dimensions to get a precise quote and suggested waste allowance.