Fill-dirt in Eaton, CO

Retail prices for fill-dirt around Eaton commonly range and depend on supplier and source, but expect roughly $10 to $30 per ton delivered. Hello Gravel has a 3-ton minimum; many orders in the Eaton area qualify for free delivery but some locations or next-day requests may carry an additional fee. Final price depends on volume, access, and whether you request spreading services.

Contractors in the Eaton area typically specify screened, low-organic fill with a mix of fine sand, silt, and small gravel—often called 'clean fill' or 'structural fill'—for general grading. For structural areas or below driveways they prefer compactible, low-organic material with minimal clay or large rock; for landscaping you may add a thin top layer of topsoil for planting.

Eaton experiences cold winters and seasonal freeze-thaw which can cause heaving if fill-dirt contains organic matter or excessive moisture. Use low-organic, well-draining fill installed in compacted lifts and provide good surface drainage to minimize frost heave and settling over time.

A practical rule of thumb for fill-dirt in Eaton is about 1.1 to 1.4 tons per cubic yard, depending on moisture and compaction. For planning: 1 inch of fill over 1,000 square feet equals about 3.1 cubic yards, or roughly 3.5 to 4.3 tons; our calculators and sales team can refine that for your site.

Many local contractors and excavators offer spreading and compaction services in the Eaton area, but availability varies by season and crew. Pricing is usually quoted by the hour ($60 to $120/hr) or by job; equipment rental (plate compactor or mini-excavator) is another option at roughly $80 to $200/day—get a local quote before ordering materials.

Common uses include raising and leveling yard grade, backfilling retaining walls, building house pads or garden berms, and utility trench backfill. For driveway surfaces or areas with vehicle traffic, contractors typically place compacted fill-dirt as a subgrade and cap it with road base or crusher-run for durability.

Permitting depends on the scope of work and location; simple yard grading often needs no permit, but significant regrading, fill in a floodplain, or changes to drainage may require a Town of Eaton or Weld County permit. Also check your HOA rules for restrictions on changing yard elevations; when in doubt contact Town of Eaton Public Works or your HOA before ordering.

Yes. Winter weather, snowplow priorities, frozen or muddy roads after snowmelt, and irrigation-season wet fields can limit truck access or require special equipment. Hello Gravel advises scheduling at least 2 business days for standard delivery and to note any tight access or gate codes in Order Notes so the hauler can assess feasibility.

Fill-dirt is typically the least expensive option for bulk volume and is intended to raise grade or fill voids; it is not ideal as a finished driveway surface. Crusher-run or road base contains angular rock and fines designed for load-bearing and drainage and is a better long-term choice for driveways, while topsoil contains organic matter suited for planting and lawns.

Properly placed and compacted fill-dirt can remain stable for many years, but expect some settling during the first growing season and plan for minor top-ups. If used under turf, allow time for settling before final grading and seeding; if used as a surface material, you should budget for annual grading or replacement since it will erode faster than engineered base materials.

Hello Gravel provides an online material calculator, local supplier pricing, and delivery scheduling to simplify ordering—our minimum order is 3 tons. For project-specific advice call our team or use the aggregate quiz; we can help estimate quantities and connect you with local suppliers and contractors familiar with Eaton's soils and climate.