Fill Dirt in Mesa Verde, CA

Yes, fill dirt is usually cheaper than decorative or crushed gravel in Mesa Verde because it is a basic, unprocessed material. Prices vary by supplier, moisture content, and delivery distance, so the final cost can change; check Hello Gravel for local quotes and remember our minimum order is 3 tons.

Prices in Mesa Verde commonly range from about $8 to $30 per ton for basic fill dirt, depending on local supply, moisture, and whether delivery is included. Use our online quote tool or call the Hello Gravel team to get an exact per-ton price for your zip code and preferred delivery date.

Not usually. Fill dirt contains finer particles that compact well for grading and structural backfill, while gravel drains and does not compact the same way, so gravel can shift under load. For most grade-raising, foundations, and under-slab backfill in Mesa Verde, choose fill dirt or a specified engineered fill unless a contractor recommends a gravel mix for drainage layers.

Coverage depends on depth and the dirt's density. As a rule of thumb in Mesa Verde, one ton of fill dirt equals about 0.7 to 0.8 cubic yards, which covers roughly 240 to 260 square feet at 1 inch depth or about 40 to 45 square feet at 6 inches depth.

Hello Gravel typically delivers with tri-axle dump trucks that carry roughly 10 to 14 cubic yards of material. For fill dirt that converts to about 12 to 18 tons per load in Mesa Verde, depending on moisture and compaction. Remember our minimum order is 3 tons if you need less.

A full tri-axle load (roughly 12 to 18 tons) in Mesa Verde will often cost between $150 and $500 before optional fees, based on the per-ton price, local supply, and delivery. For an exact estimate, request a quote from Hello Gravel for your address and desired delivery date.

Buy in bulk from local suppliers and choose standard delivery (2+ business days) to avoid rush fees. Using Hello Gravel's marketplace helps you compare local supplier rates, and scheduling delivery to avoid labor costs for spreading can reduce overall expense.

Yes, you can often add fill dirt on top of existing surfaces to raise grade, but compaction, utility checks, and local permit rules matter in Mesa Verde. For fills deeper than a few inches or near structures, call Hello Gravel or a local contractor to check for permits and recommended compaction procedures.

Fill dirt is usually used to build up the subgrade, not as the finished driving surface. As an example, for a 20 ft wide by 100 ft long driveway needing a 6 inch (0.5 ft) lift, you would need about 37 cubic yards or roughly 48 tons of fill dirt. If you plan to use fill dirt under a gravel or paved surface, get a site-specific calculation from a contractor or Hello Gravel quoting team.

'Poor man's concrete' typically refers to compacted aggregate or a gravel base used instead of poured concrete for low-cost pads. Plain fill dirt is not a substitute because it does not provide the same strength or drainage; however, fill dirt can be part of the subgrade beneath a compacted aggregate base in Mesa Verde projects when properly prepared and compacted.

Ten tons of fill dirt is roughly 7.5 to 8 cubic yards, which will cover about 2,400 to 2,600 square feet at 1 inch depth or about 400 to 440 square feet at 6 inches depth. Actual coverage will vary with the dirt's moisture and how much you compact it on your Mesa Verde site.

Measure the area (length x width) and decide how deep you want the fill in feet, then multiply area by depth to get cubic feet. Divide by 27 to get cubic yards, then multiply by about 1.3 to convert cubic yards to tons for a local Mesa Verde estimate; or use Hello Gravel’s material calculator and get a tailored quote and delivery options.