Fill Dirt in Hollywood, CA

Fill dirt is soil used to raise or level ground, typically low in organic matter and intended for compaction. In Hollywood you would use it for raising yards, filling low spots, building level pads for sheds, or bringing grades up before landscaping; it is not a finished surface for driveways or patios without a structural base on top.

Prices vary by supplier, site access, and order size, but expect delivered fill dirt in Hollywood to commonly run in the range of about $15 to $45 per cubic yard (roughly $12 to $35 per ton) depending on local availability and truck access. For an accurate quote, check your zip code on Hello Gravel and factor in any additional fees for tight access or next-day delivery.

Measure length x width x depth in feet, divide by 27 to get cubic yards, then multiply by about 1.2 to convert to tons as a rough rule of thumb (1 cubic yard ≈ 1.2 tons for typical fill dirt). For example, a 20 ft x 10 ft area raised 6 inches needs (20 x 10 x 0.5)/27 ≈ 3.7 cubic yards, or about 4.5 tons; round up and add 10-15% for compaction and settlement.

Fill dirt is fine as general backfill and for raising grades, but it is not a suitable driving surface; driveways need a compacted crushed-stone base or road base topped with a surface material. For foundation backfill or load-bearing applications in Hollywood's hilly areas, use engineered fill or follow a geotechnical engineer's recommendations and local building codes to ensure proper compaction and drainage.

Hollywood's dry summers and occasional winter rains can cause loose, uncompacted fill to shed water or erode on slopes; properly compacted fill with erosion control and drainage works well. On steep slopes you should use terracing, retaining walls, or erosion-control matting and avoid placing loose fill where runoff can wash it away.

Place fill dirt in 4-6 inch lifts and compact each lift with a plate compactor or roller until you reach the specified density; keep moisture near optimal for compaction (not bone dry). Remove organic material and debris before filling, and have critical areas tested or certified if required by your building department or contractor.

Permit needs depend on the scope of work: small lawn leveling usually does not need a permit, but significant grading, changes to drainage, retaining walls, or large cut/fill operations often do. Check with Los Angeles Department of Building and Safety (LADBS) and local planning or HOA rules before ordering fill or altering grades to confirm permit and inspection requirements.

Design grades to slope away from structures (generally at least 1/4 inch per foot), install drainage features like swales, gravel trenches, or French drains where needed, and use vegetation or erosion-control blankets on exposed slopes. Because Hollywood can get heavy winter storms, plan for runoff paths and avoid placing uncompacted fill where concentrated flow can cause washouts.

Fill dirt is less expensive and useful for raising grade, but it is not structural; crusher run or road base provides a stable, compactable, and drainable base appropriate for driveways. For a durable Hollywood driveway, use engineered road base topped with a surface such as asphalt, pavers, or compacted gravel rather than relying on fill dirt alone.

Yes; tri-axle dump trucks are the typical delivery vehicle, and tight access, narrow streets, or steep driveways can require smaller trucks, additional labor, or permits, which may increase cost and delivery time. Tell Hello Gravel about access constraints when ordering so we can match the right supplier and truck and flag any extra fees or scheduling needs.

Hello Gravel connects you with local, vetted suppliers and contracted haulers serving the Hollywood/Los Angeles area, shows upfront pricing, and lets you schedule delivery dates or request next-day service. Enter your zip code on our site or contact our team to get a tailored quote and to discuss site access, spreading requests, or special delivery instructions.