Fill-dirt in Hat Creek, CA

Delivered price for fill-dirt in the Hat Creek area typically varies based on source and distance; expect a rough range of about $15 to $45 per ton. Remote suppliers, truck size, moisture content, and screening or clean-fill requirements can push the price higher, so request a quote through Hello Gravel for an accurate delivered price to your zip code.

Many local suppliers serving Hat Creek haul material from within 10 to 50 miles, but remote quarries or pits can be farther. Delivery fees are generally based on distance, truck type, and road access; Hello Gravel shows delivery fees up front in the quote so you can see any extra charges before you order.

Hello Gravel does not publish a specific contractor directory for Hat Creek, but local excavators, landscaping contractors, and general site-prep crews typically handle fill and compaction work. Check your county building department, local Facebook groups, or sites like Angie’s List and HomeAdvisor for contractors with local experience and ask for references and proof of compaction testing.

For driveways in Hat Creek you should use a well-graded, compactable granular fill (often called road base or 3/4u0022 minus/crusher-run) rather than loose, organic-rich fill-dirt. If you must use fill-dirt for leveling, specify clean, non-organic material free of roots and large debris and have it placed and compacted in thin lifts by a contractor; engineered fill is best for structural areas.

One cubic yard of fill-dirt typically weighs about 1.2 to 1.6 tons depending on moisture and particle makeup; a reasonable rule of thumb is 1.3 tons per cubic yard for planning. Hello Gravel’s minimum order is 3 tons, and common orders for residential jobs in rural Hat Creek are 3, 5, 10 or a truckload (often 10 to 15 tons for a tri-axle).

Yes — grading, fill placement, and erosion control are regulated at the county level and by California stormwater rules for larger projects. Before moving material, contact your local county planning or building department to confirm permit requirements, grading limits, and erosion/runoff controls; for work near streams or wetlands additional permits may be required.

Fill-dirt with high clay or organic content can hold water, settle unevenly, and be prone to frost heave during cold months, so drainage and compaction matter a lot in Hat Creek’s climate. For areas affected by freeze/thaw, use free-draining granular fill, slope the site for runoff, and install sub-surface drainage where needed to reduce settlement and heaving.

Compact fill in thin lifts (typically 6 to 8 inches loose) with appropriate equipment (plate tampers for small areas, rollers for larger areas) and moisture conditioning to achieve uniform density. For building pads you should target standard compaction levels specified by a geotechnical report—commonly 90% to 95% of standard Proctor—so plan on testing during the work and hire a local contractor or testing lab if your project is structural.

Common alternatives include crusher-run, road base, and engineered structural fill; these materials are better for load-bearing areas because they compact predictably and drain well. Fill-dirt is usually less expensive per ton but may require more preparation and compaction for structural uses, so get comparative quotes for the exact material and application through Hello Gravel.

Plan to order roughly 5% to 15% extra material to cover compaction, waste, and uneven grading; 10% is a common rule of thumb for most residential jobs. For steep or highly irregular sites, or where heavy compaction is expected, consider the higher end of that range and confirm quantities with your contractor before ordering.