Fill Dirt in Baldwin Hills, CA

Yes. Fill dirt is usually cheaper per ton than crushed gravel because it is less processed and has weaker specification requirements. Gravel is often chosen for drainage and driveways, so its higher cost reflects performance and grading that fill dirt does not provide.

Prices vary by supplier, delivery distance, and whether the material must be tested or screened, but in Baldwin Hills you can typically expect delivered fill dirt to fall in the range of $15 to $45 per ton. Hello Gravel requires a minimum 3-ton order; request a local quote for an exact delivered price and any fees for access or permits.

One cubic yard is a 3 ft by 3 ft by 3 ft pile (27 cubic feet). As a practical reference, 1 cubic yard will cover about 100 square feet at roughly 3.2 inches depth, so it looks like a modest backyard pile rather than a large mound.

Most tri-axle dump trucks used around Baldwin Hills carry about 10 to 12 cubic yards, which for typical fill dirt translates to roughly 12 to 18 tons depending on moisture and soil type. Smaller dump trucks and transfer trucks carry less, and Hello Gravel will note truck type and expected tonnage on your quote.

Because soil density varies, 1 ton of fill dirt equals about 0.67 to 0.83 cubic yards (18 to 22.4 cubic feet). That covers roughly 215–270 sq ft at 1 inch depth, 108–135 sq ft at 2 inches, 72–90 sq ft at 3 inches, and 54–67 sq ft at 4 inches.

The amount depends on how deep you need the fill. For 1,000 sq ft: 1 inch requires about 3.1 cubic yards (roughly 4–5 tons), 2 inches about 6.2 cubic yards (7–9 tons), and 4 inches about 12.3 cubic yards (15–19 tons). Always order 5–10% extra to allow for compaction and settling and confirm exact numbers with our volume calculator or a Hello Gravel quote.

Total cost for a truckload depends on material unit price, distance, truck type, and access restrictions; a tri-axle load typically carries 12–18 tons of fill dirt. For an accurate delivered price, request a Hello Gravel quote that accounts for local driving conditions, street and alley access in Baldwin Hills, and any site-specific fees.

For small landscaping fills you usually do not need permits, but any structural work, large grading, retaining walls, or changes to drainage may require permits from the Los Angeles Department of Building and Safety. In urban neighborhoods like Baldwin Hills, consider soil testing if you suspect contamination or if your project requires engineered compaction; our team can advise when testing is recommended.

Drivers may be able to perform tailgate spreading at their discretion, and you can request this service at checkout, but it is not guaranteed. The driver will assess access, safety, and slope before deciding whether spreading is possible.

Clear the intended drop area of vehicles, low-hanging branches, and obstacles, and mark the exact drop point with flags or stakes so the driver can see it. Verify access for a tri-axle dump truck, note any street parking or permit restrictions, and tell Hello Gravel about tight driveways or steep slopes so we can match the right truck and crew to your job.