Fill Dirt in Semora, NC

Fill dirt is native soil used to raise or level ground; it usually contains clays, silts, and some gravel but little organic matter. In Semora and the wider West North Carolina area it is commonly used for lot grading, leveling yards, backfilling around foundations, and raising low spots before landscaping. It is not the same as topsoil and should usually be covered with topsoil or structured drainage when used for lawns or plantings.

Delivered prices vary by supplier, haul distance, and whether the material is screened or unprocessed, but a typical range in the West North Carolina region is about $10 to $25 per ton delivered. Pricing can be lower for large orders and higher for long rural hauls, tight access, or material that has been screened. For an exact local quote, use Hello Gravel to check avaIlability and pricing for your zip code.

Both screened (cleaned of large clods and debris) and unprocessed fill dirt are commonly avaIlable, but avaIlability depends on local pits and the season. Hello Gravel connects you with local suppliers and haulers in the Semora/West NC area so you can see which type is offered, compare prices, and schedule delivery. If you need screened material for structural work, request that specifically in your order notes.

Hello Gravel's minimum order is 3 tons, standard delivery lead time is 2+ business days, and next-day delivery is avaIlable for orders placed before noon CST for an additional fee. Many local suppliers in West NC offer free delivery for nearby jobs, but rural or hard-to-access Semora locations may incur extra fees or fuel surcharges ranging from modest to higher amounts depending on distance and site access. Always confirm delivery placement options and any additional fees at checkout.

Fill dirt alone is usually not a good long-term driveway base in Semora because clay-rich fill can hold water, heave in freeze-thaw cycles, and rut under vehicle loads. For driveways, contractors in this region typically recommend a compacted subgrade topped with crushed stone or aggregate base to ensure drainage and stability. Fill dirt is better suited for grading, raising low areas, or as subgrade material that is pRoperly compacted and covered with appropriate base materials.

First calculate cubic yards: (square feet x depth in inches) / 324. Then convert cubic yards to tons using a local estimate; for West North Carolina clayey fill, use about 1.2 to 1.4 tons per cubic yard (we commonly use 1.3 tons per cubic yard for estimating). Example: 1,000 sq ft at 6 inches deep = (1,000 x 6)/324 = 18.5 cubic yards, which at 1.3 tons per cubic yard is about 24 tons; add 10-20% for compaction and waste when ordering.

Many local contractors in the Semora/West NC area provide compaction as part of grading or sitework, because pRoper compaction is important for stability. Costs depend on job size, access, and equipment; homeowners can expect anything from a few hundred dollars for small jobs to over $1,000 for larger or difficult sites, while equipment rental (plate compactor or roller) is often $60 to $150 per day if you DIY. Ask contractors for a written scope that specifies compaction level and testing if the project involves foundations or septic systems.

Use fill dirt when you need to raise grade, fill low spots, or backfill trenches and you don't need fertile planting soil. Use crushed stone or engineered aggregate for driveway bases and structural support because it drains and locks together under compaction. Use topsoil only for the surface where plants or lawns will grow; for septic and foundation backfill follow the local health department or engineer's specifications, which often call for clean fill or specific compaction standards.

If used as a driveway base, fill dirt will likely require more frequent maintenance—pothole repair and regrading—because clay and fines hold water and can deform. For landscaping and lawn grading, pRoperly compacted fill covered with topsoil and seeded will perform well long-term, but erosion control and pRoper drainage are important during rainy seasons. For structural uses, expected lifespan depends on pRoper compaction, drainage, and whether the right material (clean fill vs screened) was used.

Semora is in Person County, and county rules apply for grading, erosion control, and septic work. Permits may be required for significant grading, stormwater changes, or septic alteration; septic systems typically require approval from the Person County Health Department. Before moving material or changing lot grades, check with Person County Planning & Zoning and Environmental Health to confirm permit needs and local standards.

For foundations and structural work, use low-organic, well-graded clean fill or engineered fill specified by an engineer; screened fill with minimal large debris is often requested. For driveways, avoid pure fill dirt as the wearing surface—use compacted fill for subgrade but top with compacted crushed stone. For lawn grading, screened fill or general fill compacted and covered with several inches of quality topsoil gives the best results for seeding and drainage.

Semora pRoperties may have narrow lanes, steep driveways, or limited turnaround space which can affect dump truck access and where material can be placed. Measure clearances, note overhead wires, fence lines, and soft ground, and add delivery notes when ordering; drivers may not be able to tailgate spread and will work at their discretion. If access is tight, request a call from the driver before delivery or consider smaller truck options if avaIlable through Hello Gravel.

As of today, we require 2 business days for delivery.

Use our material calculator here: https://hellogravel.com/calculator/ to enter the length, width and depth measurements of your project. It will automatically calculate the cubic yards/tons needed. If you are unsure how much to order, contact our team for guidance.

Please type in your zip code on any product screen and it will let you know if we service your area. The chances are that we do!

The material will be delivered via dump truck. If your order is under 20 tons, then it will likely be just one dump truck load. If your order is more than 20 tons, it will be more than one dump truck load.

Absolutely! Try our aggregate quiz here: https://hellogravel.com/aggregate-quiz/ Alternatively,you can call us, chat with us (box in the bottom right corner of the website), or email us!

We cannot get out of the truck and manually spread it. However, depending on the location, safety, and comfortability of the driver – we may be able to tailgate spread your material. This involves pulling the truck forward as material is being dumped to make it easier for you to distribute material after delivery.

The minimum order size is 3 tons.

Hassle Free! Our goal is to make the buying process for gravel and other aggregates as easy and seamless as possible. Enter your zip code on our site, select how much material you need (see below FAQ’s to determine order size), select the date and time frame you would like your material delivered at Checkout, and place your order with any major credit card. After the order is placed our in-house support team will contact you to confirm the details. We will send additional confirmations on the day before and the day of delivery. On delivery day, a dump truck will arrive to dump the materials at your specified location. We request that you have someone available to accept the delivery so that we can make sure to dump it in the correct location. That’s it!

No, because we are a national supplier, we utilize our existing network of suppliers across the country. Therefore, the materials will likely be delivered from a contracted trucking company.

We specialize in making the aggregate buying process as easy and seamless as possible by managing the process from end to end. We have a network of suppliers that we source the materials from where we have negotiated rates. However, we do charge a markup and because of this you may be able to find the materials cheaper on your own. But if you want a hassle free experience, then we are for you!

Please fill out the Quote Request form and we will work up a quote for you! https://hellogravel.com/quote-form/

Although uncommon, due to regional sourcing, the type and color of our materials may vary somewhat from the images on our website, reflecting the unique geological offerings of your area. Please communicate any specifications you desire to our team so we can consider them during the sourcing process.

Please contact our customer service team promptly if you experience any delivery or product quality issues. We will work to resolve them satisfactorily.

We are headquartered in New Orleans, LA. However, we have a network of suppliers across the country from which we provide the materials.